Bar Glass Washer for the Sink, Brushes and Rinse Jets, 370x200mm

For the bar that washes glasses by hand during service. When the bar is full of customers the clean glasses run out before the orders do, and the machine has its own cycle: the bar glass washer puts a glass back into service in a few seconds, at the sink, without waiting for the basket.

For pubs and beer bars. The manufacturer states that it also takes German stein mugs with a handle and pint glasses, which are the glasses that do not fit in small hand brushes.

For anyone who uses a hand brush today without running water. With the direct connection the rinse is always clean water, and the glass comes out of the second compartment already rinsed, ready for drying.

Place the unit in the sink, connect the 3/8 inch water hose supplied in the box and open the tap. The 4 PVC suction cups hold it still on the bottom of the sink.

The glass goes upside down onto the brushes and is turned: the bristles wash the inside and the outside together. Then it moves to the rinse compartment, where the jets spray water inside and outside the glass at the same time. Excess water runs out through the overflow when it reaches the brushes.

The central brush comes out

The central brush is removable: it slides out for cleaning at the end of service, and it is replaced when the bristles wear, without throwing the whole unit away.

Cold water

The manufacturer states that the bar glass washer cleans well with cold water, below 30°C. The sink does not need hot water, and a cold glass stays cold for the next drink.

Where it sits on the bar

The unit works where the glasses already go back: in the back bar sink. The bartender takes a dirty glass, washes it on the brushes, rinses it in the second compartment and sets it down to dry, without leaving the station. The machine, where there is one, keeps its cycles for the full baskets.

Specifications

• Dimensions: 370 x 200mm, height 360mm
• Glasses: diameter 50 to 140mm, height up to 240mm, including handled mugs and pints
• Body: ABS
• Bristles: polypropylene, removable central brush
• Rinse: jets inside and outside the glass, in a separate compartment
• Water: direct connection, cold water below 30°C
• Base: 4 PVC suction cups
• In the box: 3/8 inch water hose, 70cm long

The manufacturer does not state the weight, the water flow rate or the working pressure.

The bar glass washer and the hand brush

The catalogue also has the glass washing brush with suction cups, with no water connection: it is used in a sink full of water. The bar glass washer adds the second compartment with the jets and running water, and takes glasses up to 240mm tall.

The more you buy, the less you pay: 4 pieces -5%, 6 -7%, 8 -10%, on the same item. The discount applies automatically in the basket.

Bar glass washer FAQ

Does it need hot water? No. The manufacturer states it works in cold water, below 30°C.

Do beer mugs fit? Yes: up to 140mm in diameter and 240mm tall, including German stein mugs with a handle and pint glasses.

How is it connected? With the 3/8 inch hose, 70cm long, supplied, to the tap or to the water connection at the sink.

Can the brush be cleaned? Yes, the central brush slides out.

Brushes, trays and the rest of the cleaning kit for the bar counter are in the Basics category.

Dispatched from Rome, Italy.

Download the 5-step guide (PDF)